Jump to content
EwinRacing Flash Series Gaming Chairs
jonilink

Im about to give up! Beep shut down Sager/Clevo P170EMx

Recommended Posts

Specs:

Sager branded Clevo P170EM 

16gb ddr 3

AMD 7970M

i7-3820QM

BIOS 1.00.04bLS2

 

 

I'm working on this laptop for a friend and it will NOT stay on more than a couple minutes before it shuts down.  I have tried everything that i can think of and it still shuts down.  Im thinking it some kind of thermal or video card problem but I cant quite narrow it down.  

 

here are the things i have tied:

 

cleaned/re greased both fans.

cleaned all heat sinks fins

lapped and reapplied thermal paste

reapplied thermal tape to the GPU

replaced CMOS battery

reset CMOS

removed/reinstalled all drivers for iGPU an the 7970

tested all ram in a seperate latop top individually

swapped fans to test headers

 

After all of this it still will beep about 20-22 times and shut down it is in no way getting hot the fans still spin but the computer still shuts down.

What else can i try ? I can't be the only one who has this problem. I've added a file that show the bios version.

 

 

 

20161105_123604.jpg

Share this post


Link to post
Share on other sites

Do you have a link to the correct bios?

Sent from my SM-G935V using Tapatalk

Share this post


Link to post
Share on other sites

That shutdown is due to the laptop's embedded controller being unable to read the 7970m's thermal sensor. The P170EM cannot read a Dell 7970m thermal sensor, and you would get the exact behavior that you are describing.

Share this post


Link to post
Share on other sites

Ok well this laptop shipped with this video card and had been working fine since 2012 are you saying the video card is bad?

Sent from my SM-G935V using Tapatalk

Is so why would it not boot when I remove it and run off the on board gpu?

Sent from my SM-G935V using Tapatalk

Share this post


Link to post
Share on other sites

Clevo systems interpret no dGPU as an overheating dGPU.

 

Either the 7970m is dying, or your motherboard's emdedded controller is dying. Its probably the card though. Can you get the card to play a game before the laptop shuts down? Is the 7970m listed with error 43 in the device manager?

Edited by Khenglish

Share this post


Link to post
Share on other sites

The laptop seems to run for a minute or so but after awhile it starts beeping and shuts down

Sent from my SM-G935V using Tapatalk

The laptop seems to run for a minute or so but after awhile it starts beeping and shuts down I don't see error 43 in even viewer but if it is in there I don't have enough time to find it before the computer shuts down

Sent from my SM-G935V using Tapatalk

Share this post


Link to post
Share on other sites

7c38985fc49bb8bf0fb3aba74b5d1654.jpg

Sent from my SM-G935V using Tapatalk

I've updated the bios and it still beeps and shuts down. Still boots into windows fine so I'm assuming it was a success.

Sent from my SM-G935V using Tapatalk

Share this post


Link to post
Share on other sites

I guess this is the end for this laptop. Shame for how much was spent on it that it's not fixable

Sent from my SM-G935V using Tapatalk

Share this post


Link to post
Share on other sites

u could replace the gpu thou. but otherwise keep in mind how old the em is... release 12, 5 years is a long time 4 a laptop

Share this post


Link to post
Share on other sites

It is an old laptop put the person who bought it still remembers paying over $3k US dollars for it. Thanks for the help when I get the time I'll try everything suggested. As of now it is still resetting after 22 beeps.

Sent from my SM-G935V using Tapatalk

Share this post


Link to post
Share on other sites

Was anything ever spilled on the laptop? Or maybe on a thermal repaste paste got on the connector. I would try pulling and reseating the card. Maybe the thermal readout connections are dirty.

 

Its very odd that the card is working, but not reporting temperature.

Share this post


Link to post
Share on other sites

Did you update the EC with the BIOS?

 

Also second hand 680M's or 7970M's aren't that expensive, they are rare but only go for a couple hundred on fleabay down here in Oz. A 3820QM with the extra turbo bins you get from an unlocked BIOS like Prema's gets up over 4GHz which is still plenty fast

 

They can be upgraded to 980M too which brings it up to spec in the GPU department too (but you may need a geforce heatsink instead of a radeon one). If you are confident the rest of the unit will last.

Edited by bennyg

Share this post


Link to post
Share on other sites

Have u tried to changing hd7970? Most of the time the gpu cause the problem especially amd radeon.

Sent from my SM-G935F using Tapatalk

Or if you know people who can reball, try reballing your gc.

Sent from my SM-G935F using Tapatalk

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Similar Content

    • By Zauih840
      Hello, as the title states, I would be very happy if someone could give me the link to the mod, apart from that, what version should I install?, as I've seen that some models have v1 and v2.
      My other questions are: what do I have to do to install a new GPU?, (9xx series)
      And what mods do I have to use to have a 10x0 series (and which are compatible).
      I have the Clevo P150SM(model)/P150SM-A(product code) (2 models on the sticker) with stock bios (it says copyright 2012, so I guess it's the 1st version) with a 4710MQ and 870M.
       
      I would be very pleased if someone could hand me the link.
      Many thanks in advance.
    • By kodol
      Hi, 
       
      I need remove WIFI whitelist from Lenovo Thinkpad Edge E431 laptop.
      bios version is HEET52WW
      Is it possible to remove whitelist on this bios version?
       
       
    • By rajsinghfan
      UEFI BIOS Version: GJETA4WW (2.54)
      UEFI BIOS Date (Year-Month-Day): 2020-03-37
      ME Firmware Version: 9.5.60.1952
      Embedded Controller Version: GJHT30WW (1.14)
       
      I need Battery Authentication whitelist Removal because my laptop showing "the battery installed is not supported."
       
      Result.rar & .rom file: https://www.mediafire.com/file/byxsoqpg4j3od25/result_rar_and_rom_file.zip/file
    • By Brian
      I went with Intel 13900K + RTX 4090 this gen, how about you? 
    • By DoenerBoy123
      Hello guys 
       
      I've got a pretty weird problem with my M18x R2. I already searched the web but couldn't find an answer. A few days ago I changed some settings in the bios, if I remember correctly DMVT Pre-Allocated.
      After saving this setting the notebook refuses to even POST. I get no beep errors or anything. If I press the power button the system turns on, the leds turn on and then the system shuts itself off. I already reset the cmos, the IME, tested different configurations and so on. If I remove all the memory sticks I actually get the memory error code. At this point I'm pretty sure that the bios got corrupted for some reason when saving these mentioned settings. Did anyone had a similar problem and got a solution for this? I repaired lot's of notebook but never had an error like this...
      The Bios installed is the a15 unlocked.
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.