misiozol

I see no problem here, move games to hdd check that all is working and clone system hdd do ssd , so where is problem ? and no egpu will not work on gpt .

Load custom bios to gtx1080 best way to overclock it

Install ONLY driver in custom settings, do not install other junk

Can u tell me why not just clone hdd to ssd ?

Well any how it's very complex, you will not know if u not try that's specialized software can do miracles

I do not see how it could be @ fault if fans are driven direct by card , first card would die then fans, only option is to check card for fault but that is where warranty comes in

Contact owner of setup1.35 and ask him

So it's warranty claim

Have u try using setup1.35 this is easiest way to resolve lots of issues

Is card not OC ? that's very strange issue , are u able to pull plug from fans without voiding warranty ? if so try to supply them with 5v or 12v

That was quick

If u have ca$h then get gtx1080Ti

No , your laptop must boot first, there is no switch that it will boot b4 laptop only delay in POST is adjustable 0/75/150ms

Have u try read manual

It needs to be connected on boot, just change timing switch on GDC

then share this revelation

H4 bulbs from car , 2 of them should do fine 55+60W and 55+60W , configuration is variable good to have some multimeter as well, any cheap will do

I do think that ur PSUs are garbage , I do have gtx980 and tested 5 or 6 different psu even 24A one, and all have same issue sudden request of power from gpu is treated as short circuit as other circuits have no drain on them and shuts of for a milisec to test this circuit, for GPU this is to much of voltage drop and it sends reset command .

Suggestion I did put , most likely PSU is dying what amps have 12V line in psu ? 350w is total for psu

For this to run smooth u need @least ~25A on 12V line but safer would be 25-30A

Deal with it , that's just way thing are

dude u dont need to by anything, what does HWiNFO saying on bus speed ?

what HWINFO is reporting on speeds ?

Do u have any way of checking voltages ? multimeter or similar ? mine drops to 11.4V on 12V line . Perhaps PSU does not hold voltage .

Have same issue but on gtx980 , tell me have u extended in any way hdmi data cable ? as well what PSU u have ?