billz12oz

Hi Nando. I tried your suggestion. I ran DDU and cleaned my laptop of all nvidia entries. I then booted into eGPU setup and made sure my dGPU was being disabled by pressing f3 when I highlighted over the dgpu [on] option. I then ran my startup and made sure my dgpu was off. I then installed the drivers and everything is still the same. Same issues. I do have another question: the first line in my startup.bat is "call iport dGPU off" doesn't that turn off my dgpu? Here is the entirety of my startup.bat call iport dGPU off call vidwait 60 call vidinit -d %eGPU% setpci -s 4:0.0 BASE_ADDRESS_5=2001 setpci -s 0:1c.2 1c.b=20 1d.b=20 call pci :end call chainload mbr

Problem description1. What's the problem? 1: I can't get my gpu to display on another monitor despite the fact that device manager says my gpu is running fine. 2:Additionally gpuz can't give much info on the status of my gpu. 3:Geforce experience also doesn't seem to be working properly. 4:When I attatch my monitor to the gpu, nothing shows up and everything is displayed on my internal LCD. I tried both display ports.2. Have you consulted the Troubleshooting FAQ to resolve the issue? Yes. I've also consulted this guide for my laptop model.3. Have you consulted the Pre-Purchase FAQ --> "2. How can I check if my notebook is compatible with an eGPU?" Yes. It has an express cardPlatform Description1. OS Windows 10 64 bit2. System Lenovo Thinkpad W5403. RAM 16gb4. eGPU used PE4l v 2.1b (expresscard) trying to run a GTX4805. PSU specification (especially the +12V max current) 500W EVGA Diags https://dl.dropboxusercontent.com/u/39783300/diag.rar My startup.bat should be inside

Hi nando. I tried everything there. I even posted on that thread but I had no response. Any other resources i can revert to? I don't know if my pe4l is faulty. The gpu is spinning, i see 1 yellow and 1 green light but nothing shows in device manager.

Hi gothic860, I'm having trouble getting my w540 to recogtnize my egpu. It doesn't show up in device manager. I have not installed egpu setup because my drive format is UEFI/GPT instead of MBR. Do I have to convert my drive before it will get recognized? I'm trying to install a gtx480

Hi Nando4. I don't know if this is the correct place to put this, but I recently tried setting my egpu. I'm running a GTX480 with a Pe4l 2.1b setup for my Lenovo w540 which runs windows 10. I tried plugging the express card in, but it's not being registered under device manager. I tried the 3 steps that you suggested on your FAQ. Any ideas?