jukeboxpanda

Sry for all the posts I've missplaced my panisbutton. I think it's the touchscreen flatwire that is the problem, as mentioned the blue plastic protection fell of from its end, and I dismantled the comp a couple of times just to get it right so it's propably damaged from the looks of it and the weird boots the comp does. Do you think the symptoms fall under the wire being the problem? If so what is it called so I can buy a new one (if that's even possible). I't goes from the motherboard to the touchscreen panel.

NVM again... after evverything worked I just had to adjust the keyboard cause it wasn't flat enough... and the same prob came back, it's the graphic card fan that starts when I put in the powerchord... I checked the display wires and touchpanel wires for hours but they appared to be fine exept for the little bending on the touchpanel wire as mentioned earlier that makes it a big fuss to attach... So back to step one... HELP, why does the fan to the gpu starts when I attach the powerchord, just as earlier? As I was reattaching the keyboard it must be one of the wires that has to do with the power button or gpu... but whatäs wrong with them?

NVM got it starting it was that damn LCD cable that Michael also struggled with everythings fine now, it was only the LCD prob, i thought the whole comp was dead but that cause the fans where spinning so silent Need to check temps now thanks for this guide

I need urgent help. So I followed this guide to repaste my gpu and cpu cause of high temps and cause my comp was dusty as an old mummy. After putting it all together again (managed on like my 3 atempt.. always missing some small wire that had to be drawn over or under the components), the computer won't start, nothing happens when I press the powerbutton, no light nothing. If I attach the powerchord the fans start but there is no screen and no light, I can however at this stage turn the comp of by holding down the powerbutton. I've checked all the cables inside, and I can't really find anything that could be wired the wrong way. I'm thinking that the cable attached to the touch controll and powerbutton panel would be the problem, the blue little clip on the wire fell of, the one you pull to remove the cable and to hold it at place, and the input end is a little bent in the corner... I've never opened a laptop before only built some desktops. Were did I go wrong? Is it the cable or something else? Please someone answer :/