Search the Community
Showing results for tags '980'.
Found 4 results
On the Eurocom web site (where one can purchase a GTX980M upgrade kit), they state that their modded drivers require Win8+. This seems strange to me, considering my desktop still runs Win7 with a 980Ti and the Nvidia drivers are fine... Is anyone running the 980M in their R4 with Win7..? Is it possible to mod Win7 drivers for this card..?
Hi everyone! I have aw17 (4900mq, 330W psu) upgraded to 980m 4G (1617 dev. id, g-sync). Gpu-z sensors monitoring informs about downclock to 937MHz under full gpu Driver ver. 372.70 (self modded inf). Stock bios. WIn10. Any way to fix this?
Ok so I do I lot of work on Rhino 3D, Sketchup and too Revit. I also use Maxwell and sometimes VRay for rendering. My current 15" Macbook pro with Iris pro graphics really sucks for this. When I move models around they get laggy and often freeze and crash. I do expect rendering to always take a while. Should I go with the Thunder2 and a GTX 970 with a PSU or would I be fine with the built in AMD R9 m370X of the higher priced macbook. The GTX kills it on benchmarks however the GTX requires a PSU and its hard to take around.... Thanks!
Hi, I've not posted on here since I built my eGPU for my 2015 MacBook Pro over a year ago. That unit was an Akitio Thunder2, RM 650W PSU, CoolerMaster 130 case, powered riser cable with a Zotac GTX 770 card. It's mainly used for playing Elite Dangerous on and it has been working perfectly. Recently I had the opportunity to upgrade the GTX 770 to a GTX 980 Reference card. It was pretty much a straight swap out except for the cards power connectors. On the GTX 770 these were 1 x 8-pin and 1 x 6-pin connectors. On the GTX 980 these are 2 x 6-pin connectors. Simple enough with my 650W PSU I just switched connectors. I am using the same powered riser cable for the PCIe connection. The unit boots up and works okay on Windows 10 via the display port connection. It will even play Elite Dangerous on Ultra settings and give a steady 60fps. So all good! Why am I posting here and asking for help??? Well, I noticed that when playing Elite Dangerous I could hear a high pitched electronic screaming noise coming from the unit. At first I thought it was the GTX 980 power coil as apparently they do sometimes do this. However on closer inspection the noise is coming from the Akitio board. It appears to be power related, so I tried to stress the card (and hopefully use more power) by using 3D Mark 11. Sure enough when running the benchmark tests the Akitio board makes a very high pitched electronic screaming noise. The noise stops when the tests stops. So it is caused by load on the graphics card and therefore I presume power, or lack of it. Do you think power is the problem here? If so, what should I do? I don't use the 2.5mm power adapter input on the Akitio board because my powered riser cable has a MOLEX adapter attached to it. Should I scrap the powered riser cable and get a non-powered version and then create a MOLEX to 2.5mm DC adapter plug for the Akitio power socket? Would that supply enough power for the GTX 980. The GTX 770 never had this problem, but I presume the GTX 980 draws a lot more power under load. I've attached some pictures below. Any help or advice you can give would be appreciated. Thanks, X6