Aganebifutigo

15 hours ago, Tech Inferno Fan said:

 

Experiment with chainloader settings (mode=MBR/bootmgr, remap=selected/inselected) until can get it to chainload to the Windows bootmenu upon which select Windows. The you too set your eGPU gear to run at Gen1 speed using the PCIe Ports->Gen1 Setup 1.30 menu. If using a EXP GDC then note it doesn't use a soldered cable like PE4C 3.0 does and is reknown for causing Gen2 instability as a result.

So, does this mean chainload should work even without a functioning eGPU? I have tried every setting i found but could not get it to run. could this be a hardware issue?

Hello! i hope some one can help me,

I set up everything as described ("buster"-Adapter, 600W xilence PS, Gigabyte GT730)

After Windows starts i get a nvlddmkm.sys blue screen, sometimes a dxgkrnl.

I read up on some suggestions that this might be caused by a driver conflict with my dGPU, a ATI card.

I tried a few fixes, but non really worked.

In setup 1.30 the card is only detected after some time in the Dos-Menu, and when i check the status, it says inaccessible. chainload failes with MBR and MBR2

Unfortunately i have no means of testing the Hardware but i`m hoping someone can tell me this is a simple software issue

help would be greatly appreciated! Thank you