Erilson

On 3/9/2016 at 5:48 AM, luferbur said:

Hi everyone i have an error with the Exp Gdc Beast V8 

 

My setup:

-Acer aspire 5750g (this model came with 1x4gb ram but i upgraded to 2x4gb ram)

-Exp Gdc Beast V8

-Gtx 750 Ti 2gb

-Power supply Nox urano sx 500

 

I connect the  1 x 20/24 pin and the 1 x 4 pin of the power supply to the cable the EGBeast came with

And I use 2 molex to power the gtx750ti

 

As indicated in the manual i had to change the bios graphic mode to integrated and diseable the network boot to start the pc and not having the black screen issue so i did.

 

The problem I have is that after having installed the gcard drivers and have it recognised by pc, I have this problem

 

 

It says its error code 43 

I've tried unninstalling and searching  for hardware changes aswell but no solution

 

I'd apreciate some help, thank you 

Yes, that mPCIe port will work.

Welcome to the eGPU scene, this topic is perfect for you to begin:

If you find the card to the right in your computer, that's the mPCIe slot.

I would suggest you delve into this topic for your eGPU needs.

Here your go: 

You can implement a mPCIe eGPU. 

Look in device manager, then Display adapters, and look into Driver for the specific card, and enable or disable it. Some graphics cannot run both at the same time, and may increase heat risk.

You must perform a DSDT override OR use Setup 1.30's PCI compaction. Look into link below, look into #2

What is the TOLUD for this memory adress? B0500000

Hello fellow forumers, sorry to bother you, but what is the TOLUD value for the selected port? The number says B0500000, and I can't tell for sure if it means 3.5GB or much higher/lower because of the 5 inside it.