blackydevil

That's right. As shown on the Setup 1.x page.

ok. done. waiting for your mail!

thank you!

How do I donate to setup 1.x? Just send 25USD to Tech Inferno [email protected]?

Did you check if GPU-Z is showing x1 2.0 when you put the eGPU under load? if not, then yes, will need to switch the port into Gen2 mode. Is there a BIOS option to do that? If not, then consider obtaining Setup 1.x to do it. Discount coupones were abolished after HIT stole development donations as detailed.

Thank you for your quick response!

GPU-Z shows only x1.1 under load. and there is no bios option for activating Gen2 mode. Thanks for information about the coupons.

Will setup1.x defintly work for activating 1.2? Is it complicated to setup setup1.x with windows and linux on one disk? Are future updates included when purchasing setup 1.x?

Regard

blackydevil

Hi,

I m new here. This is a Crosspost, because the NBR forum is nearly dead.

I own a Terry Mobile 1341 Pro, which is a Clevo W130EW Barebone.

Specs:

i7-3632QM

8GB RAM

256GB Samsung 840 Pro

13.3" with 1366*768

Expresscard slot

Also I own a eGPU with GTX 460 and PE4L 2.1b and a XBOX 203W PSU.

I did a DSDT override because I got Error 12.

So, to my probleme:

I only get an x1.1 connection with 2.5Gbps. But all hardware (the chipset and the graphics card) supports x1.2.

How can I force the connection speed to 5Gpbs? Do I really need Setup1.x? And may I get a discount code for setup1.x?

I hope, I will get some useful answers. Thx!

Kind regards

blackydevil