moxy010 Posted September 9, 2017 Share Posted September 9, 2017 setup i have:asus x54c,Nvida geforce gtx660,psu corsair cx600, dock i use: exp gdc v8.4d note:(originally the notebook had intel celeron b815 processor, i replaced it with pentium b970,and added 2gb of ram other than that no other hardware changes were made) first time i connected it all and powered on,gpu fans started spinnig very fast and screen was on but all black and nothing happened so i tried the delay switch but with the same result, then i connected external monitor to the gpu, finally i was able to see manufacturer logo,but then it hanged on windows loading screen(back then i had windows 7 so you could clearly see the windows logo animation stopped) so i tried to hotplug the egpu by booting with original wifi card in (mpcie) sleeping then plugging the egpu in and resuming,but always i did so i was greeted with instant crash so i went searching for answers on the internet and i learned that i should isolate pin 22 so i did, finally i was able to boot into windows (with delay set on maximum) but the card wasnt detected, i purchased setup 1.35,installed windows 10 bios (i had windows 7 uefi) but i couldn´t get it recognized even in there. im sure all the componnents are fine, i got it sucesfully runing on my older laptop (lenovo u350) thanks for all the help in advance Link to comment Share on other sites More sharing options...
Recommended Posts