Search the Community
Showing results for tags 'amd 6970m'.
Found 3 results
As the title says...... I am trying to get some pictures of the 6970m and if possible the 6990m with heatsink and back bracket (hopefully both on and off). Reason is.... the dell tech came over yesterday to replace my 460m's with 6970's and he only had the cards. After him ruining all the thermal pads and me putting on some of my own, we attempted to boot the system and got awful graphical distortion and a total green color. He called dell and told them to send the entire assembly (vid cards with heatsinks and back bracket) but I wanted to try and compare the 2 as I removed the cards again (since he left the system in pieces) and looked at how the back bracket is from the 460m's (460m has ram on the backside as well as the top while the 6970m only has ram on the top.... so the back bracket from the 460m's had a metal piece with a thermal pad to cover the ram). Any help is appreciated. They guy should be back with the parts today or tomorrow but I was hoping to satisfy my curiosity in the meantime. TIA D.
I've got the 6970M inside the M17x-R2 right now and am typing from it. Unfortunately, the same problems that plagued Ichime are also present with the Dell 6970M, namely the lack of GPU bios fan control (it stays at a single speed) and thus needs hwinfo32 to spin it up. So for now, I'm taking stock benchmark runs (vantage, 3dmark 11, batman arkham asylum, metro2033). After that the GPU is going back in the R3. The results will be made available in the up coming R3 review. I'll post a teaser pic here for you guys in an hour or so.
Ok I have mentioned that I ran into issues after I uninstalled the Dell AMD 6970M driver and replaced it with the Catalyst 11.4. Specifically, the FN+F7 functionality was lost and I had to resort to manual switching (via control panel) to the IGP. However, even when doing so, I noticed the battery life would not register higher than 2 hours. I brought this up over at NBR and Inap mentioned he got FN+F7 working fine with the 11.4 Catalyst. Batboy then made a post specifying the following: I tried the above except I did not do a reformat but rather uninstalled the Dell AMD driver and went straight to the 11.4 Catalysts. So this brings me to the point of this thread: Please share any tips/tricks you have for successfully reformatting the R3.