Hi,
Thanks for all your efforts throughout the site. It reminds me of a conversation I had just as I started uni with a guy in PC World. I had a very powerful laptop that sucked for games. Thank god eGPUs turned out not to didn't exist back then, or I may not have done well in the degree
I was hoping someone could check I have the right bits.
To connect the power supply, I have bought:
"Dell 220W DA-2AC Power Supply for Dell Optiplex SX280 745 620 755 760 USFF" http://www.ebay.co.uk/itm/182011509383
2 of Startech.com 6 inch PCI Express Power Splitter Cable
DC BARREL PLUG, 2.5X5.5MM, SCREW TERMS CLB-JL-52Y By CLEVER LITTLE BOX
2.5mm x 5.5mm Male Power Plug Jack DC Connector 14mm Long (in case I can borrow a friend's soldering equipment)
Assuming I can source a paperclip without too much effort, I think that fits the bill?
Huge thanks again! I'm excited!
Dan.
PS If I were to get a switch now, to replace the paperclip, is there anything (terminology or something) that I should consider?