400nob

I think I'm having the same issue as above but with AMD GPU

No such luck. Same errors I was receiving before hand. Can allocate no problem but will not boot correctly with Gen 2 speed set. Is this because I have a USB 3.0 on my laptop. I read that it is taken from the southbridge which could explain why it will not relocate correctly

Both checked and additional email sent.

Nando4 - I've sent you a donation for this software so I can try and remedy my errors.

I have read that section but it doesn't state, or I don't understand, how it changes lane speed differently to the version I have been using. I will issue you the funds now.

Does it mean I will not be provided with any help if you have crossed out older versions of DIY Setup? I'd happily repurchase DIY Setup if it will guarantee my issue will be resolved.

Can someone help me with my issue? I recently purchased the PE4C 2.1b DIY eGPU. I previously had the PE4H 2.4a and with the information in this forum had plenty of fun using it. I purchased the upgrade because I have a laptop that supposedly supports 5.0 GB/s. My setup: HP Probook 4530s I5-2410m 8GB Ram iGPU HD3000 dGPU disabled in the Bios eGPU PE4C 2.1b with R9 280x Graphics card Connected to the PC via Expresscard slot. <strike>DIY eGPU setup 1.10b</strike> I have successfully completed a DSDT override as I thought this would enable me to change the Expresscard port to 5GB/s but it has not. When I change the port setting from Gen 1 to Gen 2, with or without any compaction, windows will boot into a blurred low resolution desktop with the HD3000 having error 12 and the R9 280x is recognised but non functional. <strike>Would updating to DIY setup 1.30 fix my problem or have I completely missed a step that is causing the issue?</strike>

Has anybody tried to order this from the UK? I'm currently being told that it is out of stock and cant deliver.