Jump to content

jamescc

Registered User
  • Posts

    14
  • Joined

  • Last visited

Posts posted by jamescc

  1. I dun have the card, so this might not help much. But I read somewhere that Lenovo power management app can cause trouble, try uninstall it. If all method fails, do a backup and recover a clean os to know whether the problem is with the card. If you suspect it's the bios issue, revert to original bios and update to official 2.04 b4 modifying it. Hope it help

  2. I use NVIDIA Inspector 1.9.7.2 to undervolt. Please be careful then OVERvolting, if you run over 1.1V watch your temperatures and do it VERY carefully. Undervoltage on the other hand would not damage it - driver would crash or PC would turn off.

    Thanks for your feedback. I guess it has more to do to my hardware defects than software.

    I ran OCCT GPU stress test after your advice against furmark and found more than 10k error being generated in less than 10 min.

    Thanks.

  3. Usually I get these messages when voltage is too low (when I undervolt). So, I give more voltage and it runs fine.

    May i know how did you adjust the Voltage?

    My unit is Y400 Single GT750M running on Unlocked BIOS by Svl7

    according to the GPUz,

    Clock: 1058 MHz

    Memory: 2499 MHz

    Voltage: 1.081v

    The above score is when i running burn test with Furmark. Thus am i right to say it is undervoltaged?

  4. Hi Guys,

    I would like to share a story that really saved my PC and wallets from being ripped off.

    I was messing with my newly modded y400 BIOS (thanks to Svl7).

    I changed a few setting in the PCIE configuration under the Advance tab and the whole system went blank.. not even the Lenovo sign. (Should've headed Svl7's warning not to mess with thing i don't understand)

    I couldn't even enter BIOS as the display chip was shut off while the system continue to load.

    It freaked me out until i found this post.

    Edmar Hobby - Electronic: Lenovo Ideapad Y580 Insyde Bios Reset/Recovery

    I used the first method to recover from the mess

    " to the following key presses to do a factory reset of the BIOS: left, 4x down, 4x enter"

    And before i know it, my beloved computer came back to life.

    The post also teach about how to recover from corrupted BIOS running on insydeh20 BIOS system, although i was scarred to hell to try it.

    I hope the above link can help someone (as careless as me) and a million thanks to Slv7 and Edmar!

    • Thumbs Up 3
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use. We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.