deuceduzit

From Personal experience.... Always use the A03 Stock firmware when blindflashing... And most importantly be patient... Wait until it restarts itself... It will be beeping more than 20x's (its more like 80 or so in my case) ... Just wait it out... when in doubt... WAIT. Pulling power cable will end up in brick.

Hi svl7, is there a A03 unlocked bios + 11.5 OROM somewhere I can download yet? Thanks for all your help As for users wanting to downgrade... It may or may not work for you... I was successful in downgrading my bios by downloading the original stock A03 and renaming it accordingly to blindflash instructions. Make sure you wait until it restarts itself... When in doubt... WAIT... a premature shutdown is almost guaranteed brick. This is in no way safe... just wanted to post my success in hopes of helping other users.

The only thing I can see we doing different is that Annie downgraded to A03 while we tried downgrading to A07... Sent from my GT-N7000 using Tapatalk 2

It was dumbdumb from notebookreview... he was the one that initially had problems downgrading. Sent from my GT-N7000 using Tapatalk 2

Anyone else success with downgrading A07/A08 down to A03??? I did a A08>A07 and bam bricked.... Waited at least 30mins... system didn't restart so I unplugged... Then system was brick. Tried everything and its completely dead...

Don't do it.... I had it on for hours... Still bricked.

Thanks Luis, can you confirm the part number being released for the R2? Wondering of its a different part number than the one offered with the R1's???? Sent from my GT-N7000 using Tapatalk 2

Have you tried pulling the CMOS battery? Disconnect it for a minute and reconnect and power on. Sent from my GT-N7000 using Tapatalk 2

Will this mess up the ec controller? Has anyone attempted to downgrade to a07? Sent from my GT-N7000 using Tapatalk 2

Does anyone know how to blind flash back to a07 from a08? Maybe johnkss can help... Sent from my GT-N7000 using Tapatalk 2

You da man!!!!! Can't wait for the unlocked A08 thanks again brotha man. Sent from my GT-N7000 using Tapatalk 2

Wasnt it offered the first week or so of release?

From what I experienced with multiple 7970m cards... (by multiple I mean like.... 3+ different sets) They all seemed to read different voltages... I would just test the cards and if every works I wouldnt sweat it.... I went through the same dilemma a month ago... I have a set right now that would read .975 on 1 and the other 1.05 and works perfectly fine... My advice is to just ignore the volts unless cards start giving you problems.

I have been trying to get a solid answer from AW/DELL team in regards to this since the R2 came out... It looks like it was offered briefly for about a week or so... And then theres the drivers for it on the R2 page.... So not sure what to make of it...

Can anyone with the WIHD setup confirm if its working correctly with the new A07/A08 bios? I really hope the new bios fixed this problem with not being able to connect to WiHD receiver...