I have recently upgraded my laptop(an M6800 firepro 6100) and replaced it with an GTX 980m. Nvidia says that the latest driver(461) supports my card but i can only install up to 388.13 Ive tried to mod it but i can't figure it out. I can run the latest linux driver tho
I need help in fixing my Thinkpad.
I just got a T440p yesterday. It was working perfectly until the following:
I reinstalled Windows and then I installed Vantage.
I installed all the latest drivers.
I also choose to install the bios update. The bios update ran in Windows and it asked me to restart. After restarting, the screen was blank. I tried powering it off and on and I saw the Thinkpad logo but after that the screen was blank.
I tried powering on and off again and there's no Thinkpad logo now and the screen is just blank with the green power on. No sound, no nothing.
Here's what I tried:
Pressing the power button 10 times and then holding it for 30 seconds. Unplugged and battery is detachted Detached the CMOS battery and the reattached it Removed the ram, harddisk and optical disk drive. Attached the battery and inserted the charger. I turned it on and there was a couple of beeps Tried pressing FN+R and created a bootable USB I'd like to ask: How do I fix this? What do I need to do?
Can I reflash the bios in some other way? Do I need to buy a new motherboard? Will this solve the issue? It's my first thinkpad and I'm really excited but I was bummed out that this happened. Can you please help me?
Thanks in advance!
Hello everyone! I am looking for an answer to a problem I cannot find a solution to ... I purchased an Amd wx 4150 MXM GPU module su e bay to upgrade my HP 8570W Mobile Workstation which is currently equipped with a Fire Pro M4000. Once the new GPU has been installed, the PC screen no longer turns on but works only with external monitors connected via the docking station. The same happens once the drivers are updated! If I put the old card back on, the integrated monitor starts working again ... How can I fix it?
I tried a tutorial on the forum to remove the supervisor password on a X260 thinkpad but the winbond 25Q128FVPQ chip is not recognized with the programmer CH341A and ASprogramer (does not detect automatically and not manually). Plugged into the motherboard with a soic8.
Can you help me with detection?
Can I find the password with the software or do I have to write it?
Thank you so much !!!
To install the unlocked bios, I prepared and booted a freedos usb. I start the installation by typing flash.bat but every time I get the following error: Error 28: Protected Range Registers are currently set by BIOS, preventing flash Access. Please contact the target System BIOS vendor for an option to disable Protected Range Registers.
How can i solve this problem ?