I created a case for egpu using 2.5mm acrylic sheets. The first time I created a case to support a GPU + ATX psu
Now I created another one for the GPU with an external Xbox 360 203w psu.
the finish was not good but for my use it is already good.
*both cases album
*Construction of the second case
*adapting xbox psu to 8pin power (taken from 24pin)
all made by hand with the tools I had.
I have recently acquired my Dell Inspiron 15 7000, and I am interested in building an egpu setup for it. It has a USB-C port. Any recommendations/guides out there?
Hi there guys,
I've been looking into getting a new GPU for my laptop (4-lane PCI-e) and enclosure (HP Omen Enclosure) but I cannot decided between the RX 5700 XT and the RTX 2070 (non SUPER).
I did some price to performance calculations (higher is better) with some of the best prices I can currently get in the UK.
The RX 5700 XT does perform better and is cheaper than the RTX 2070 (Although the 2070 does come with 2 games) but my main concern is drivers and from what I've heard NVIDIA cards work a lot better with eGPUs than AMD.
If anyone has experience using both red & green or if anyone else has any other input i'd love to hear your experiences and input.
Managed to find a relatively cheap MSI 1070 on ebay, and after reading a few success stories that 1070's are compatible I decided to pull the trigger.
Modified the bottom case as per the photo on this FAQ page http://www.eurocom.com/ec/faqs(272)ClevoP150EM_SagerNP9150_XMG_P502_PRO. Things were going well until I went to screw the card down and felt some resistance.
Oops. Looks like that capacitor(?) with the blue on it *just* clashes with the card. Now what's weird is not all P150em motherboards seem to have this component on it - looking at replacements this component is not there. Also looking at the photos from this 1080m P150em mod (https://premamod.wordpress.com/2017/10/10/clevo-pascal-mxm-standard/), this component isn't there either. Does anyone know what this is, and if it can be removed? Or, if this could be taken off and shifted out of the way somehow, or replaced with a smaller equivalent...?
In my disbelief/annoyance/problem solving when trying to push it down, I did notice that the card has a surprising amount of flex in it and it *can* be screwed down almost completely to a level where I feel somewhat comfortable in doing... Though I'd rather not put this strain on the card if there is a way to avoid it.
Hi guys, bit of a rookie to the whole EGPU scene. Currently I have:
- MacBook Pro 2015 13inch (3.1GHz Core i7 16GB RAM)
- Razer X Core
- Apple TB3 to TB2 Adapter
- TB2 Cable (Cable Matters)
- 23inch AOC External Monitor
I am wonder about what graphics card to get to run X-Plane11 with high graphic settings?
I have purgewrangler set up and ready to use with an AMD graphics card, but am also open to the idea of an Nvidia graphics card.
Any advice appreciated. I did not buy a Windows PC as I need a Mac for various other things and wanted an all-in-one laptop.