My M18XR2 was working on Windows 10 with a 880M.
Last week, I reinstalled my system, and I couldn't get nvidia driver working...
I took the last installed modified driver, and even downloaded latest version, modified it again, nothing to do, I have same error : nvidia installation failed.
I only install the graphic driver too, it fail. The screen goes black, then light again, and it fail...
Do someone have an idea how to fix this probleme ?
After some trial and mostly error, I've come to seek help. This is my setup:
Dell Inspiron 5759 Windows 10 8 GB RAM Intel i7-6500U Internal GPU: AMD R5 M335 EXP GDC v8 via NGFF (wifi card) External GPU: AMD RX560 4GB Corsair VS350 What I've done so far: I first started with a GTX 1050Ti. My laptop did recognise that card, but obviously I got the code 43 error due to NVidia banning the use of eGPU's in their 10xx series. So I returned that card and bought a RX 560 instead. But now I have even more problems. It's either blackscreen or booting on the internal display. I've tried to hotplug (boot with wifi card, and then when in sleepmode swapping for eGPU), delay the boot by going into BIOS, turning the ATX power on (permanent power via EXP GDC). The only thing I haven't tried is the delay on the EXP GDC.
Any help is greatly appreciated.
Hello everyone, I currently use my laptop for school/work and I know I could have gotten a better one but I didn't pay for it was given to me from my job. I recently purchased an HP omen accelerator and put a MSI 1050 ti in it. Knowing this set up wasn't going to work. My laptop is a i7 HP ENVY x360 Convertible-15m-bp0xx, it doesn't have any thunderbolt ports, it has a USB Type-C port with HP Sleep and Charge. I provided the picture, look at my ignorance. Please help. Is there another way around this, I feel like intel could have came up with a substitute by now.
By Jackson Chai
I hope someone can help me out here.
I have an Acer Aspire E4-471g Laptop. Intel Core i5-4210U NVIDIA GeForce 820M 16gb DDR3 RAM 512GB SSD
I have an EXP GDC V8 Beast eGPU adapter. I use a power adapter to juice my eGPU by Dell Netzteil ADP-220AB B 12V 18A 220W P/N Y2515 REV A02
I have a Zotac GeForce GTX1050ti 4GB
The Problem:- I did the normal procedure, disable the eGPU. Took out the wifi and replace it with the mpcie cable.
Switch on the computer and I have a blank screen. No screen at all on the laptop screen nor in the external monitor.
Is there a best solution? I have seen the Setup 1.3 but I will do that if that is really the necessity.